Banks Power Chevy_GMC Trucks: Gas ’99 - 14 4.3,4.8,5.3,6.0,6.2,8.1 Intake- Ram-Air Intake System '99-08 Chevy-GMC (4.8L, 5.3L & 6.0L) Pickups & SUVs User Manual
Page 10
Figure 7
Note Direction
of air flow.
11.
Install the Banks Filter onto the
Banks Ram-Air Filter cover. Press
fit the two pieces together until an
audible snap is heard. This process will
ensure that a correct seal has been
established. Tighten Banks Filter hose
clamp.
Note: see Figure 5 to reference the
correct alignment groove to the Banks
Ram-Air filter.
12.
Place the Banks Ram-Air filter
cover onto the Banks Ram-Air housing.
Align and loosely fit the cover onto the
housing using the supplied fasteners.
13.
From the stock air box, remove
the MAF sensor by loosening the
clamp at the outlet of the stock air
box.
Note: the factory inlet seal gasket and
clamp connecting the MAF sensor to
the factory air box will be reused.
CAUtIoN: Do Not toUCh oR
ALLow ANy SoLVeNtS to eNteR
the SeNSING eLeMeNt oR
DAMAGe MAy ReSULt.
14.
Install the MAF sensor onto the
outlet of the Ram-Air Cover outlet.
Use the previously removed factory
inlet gasket and hose clamp to secure
the sensor to the Ram-Air Cover.
Rotate the sensor so that the sensor
connection is position as shown in
figure 6 to provide adequate hood
clearance. Tighten the clamp.
Note: When installing the MAF sensor
note the direction of air flow indicated
on the side of the sensor.
See Figure 7.
10
96882 v.3.0