Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Exhaust- TorqueTube system 4.0L I-6 ('00-06 Wrangler_'00-01 Cherokee_'99-01 Grand Cherokee) - Manual (Page 2)

2
96434 v.7.0
Dear Customer,
If you have any questions
concerning the installation of
your Banks Power system, please
call our Technical Service Hotline
at (888) 839-2700 between 7:00
am and 5:00 pm (PT). If you have
any questions relating to shipping
or billing, please contact our
Customer Service Department at
(888) 839-5600.
Thank you.
General Installation
Practices
1.
For ease of installation of your
Banks TorqueTubes, familiarize
yourself with the procedure by reading
the entire manual before starting
work. This instruction manual contains
8 pages of text, illustrations and parts
listing.
2.
Throughout this manual, the left
side of the vehicle refers to the
driver’s side, and the right side to the
passenger’s side.
3.
Disconnect the ground cable from the
battery before beginning work. If there
are two batteries, disconnect both.
4.
Route and tie wires and hoses a
minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. Clearance of 8 inches or more
is recommended where possible.
5.
When raising the vehicle, support it
on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides; put the transmission in
park; set the hand brake; and place
blocks behind the rear wheels.
Caution! Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry or
any other item not intended
specifically for this use.
6.
During installation, keep your work
area and components clean to avoid
possible dirt entry into the engine.
7.
For proper performance from your
Banks components and to prevent
engine damage, it is essential that
your engine’s fuel system be capable
of delivering fuel at the factory’s
specification. We have often found
vehicles with inadequate low pressure
side fuel delivery that isn’t apparent
until performance modifications are
made.
Tools Required:
• 1 ⁄
4
" and 3 ⁄
8
" drive ratchets with inch
and metric sockets and 3 ⁄
8
" drive
extension
• Inch and metric combination or
open-end wrenches
• Standard and Phillips head
screwdrivers
• Standard and needle-nose pliers
• Pocket or X-Acto knife
• Clean shop towels or rags
• Inch-pound and foot-pound torque
wrenches
Highly recommended tools and
supplies:
• Compressed air source and hoses
• Penetrating oil or light lubricant
spray
• 9 ⁄
16
" swivel socket el-ldisconnect tool