Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Exhaust- TorqueTube system 4.0L I-6 ('00-06 Wrangler_'00-01 Cherokee_'99-01 Grand Cherokee) User Manual
Page 4
4
96434 v.7.0
disconnect tool is needed for the fuel
line release. (Disconnect tool can be
purchased at a local auto parts store.)
If fuel-line disconnect tool is
unobtainable, the fuel rail and fuel line
assembly can be removed by
disconnecting the four (4) 8mm bolts
from the intake manifold.
5.
Disconnect the two (2) O
2
sensors
located on the exhaust manifold.
Disconnect the O
2
sensor from each of
the headpipes. Label the O
2
sensors so
that they can be reinstalled in the
same locations.
6.
Loosen the power steering set
screws located on the pump. Loosen
belt tensioner and remove the power
steering belt. Next, disconnect the
power-steering pump and bracket
from the intake manifold.
7.
To assist in the exhaust manifold
removal and installation, remove the
plastic pins holding the driver-side
inner fender mud protector. Remove
the mud-protector. Retain the pins for
reassembly (see
Figure 2).
8.
Remove the four (4) 10-mm bolts
from the factory head pipes.
Disconnect the headpipes from the
exhaust manifold.
Note: The headpipe/pre-catalytic
converter assy. may be disconnected
from the main catalytic converter
Figure 2