Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Exhaust- TorqueTube system 4.0L I-6 ('00-06 Wrangler_'00-01 Cherokee_'99-01 Grand Cherokee) - Manual (Page 5)

flange to assist #1 and #5 bolt removal
and install.
9.
To assist in the removal of the
exhaust bolts, spray the
intake/exhaust bolts with penetrating
oil. Loosen intake/exhaust bolts 3,6
and 7, but do NOT remove (see
Figure 3). These bolts act as supports
for the exhaust manifold. Remove all
remaining intake / exhaust manifold
bolts and set aside hardware for re-
assembly (a
9 ⁄ 16 " swivel socket may
save time).
10.
Remove the intake manifold from
the engine block. Remove the
remaining bolts (bolts 3,6 and 7) and
remove the exhaust manifolds.
11.
Inspect the exhaust and intake
mounting surfaces of the cylinder head
and remove any rust or carbon that
might prevent the TorqueTube or
intake manifold from sealing. Be
careful debris does not enter the
engine ports.
12.
Install the supplied gasket onto
the cylinder head dowels. Place a
small amount of anti-seize on the
threads of each of the eleven (11)
factory intake and exhaust bolts.
13.
Install TorqueTube manifold onto
the cylinder head and support with
loosely installed bolts in locations 3,6
and 7. Note: The heat shield over the
Figure 3
96434 v.7.0
5