Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Speed Control- SpeedBrake '07-10 (iQ) For use with Banks iQ Only - Manual (Page 8)

8
97240 v.6.0
Figure 5 Driver Side Firewall engine Compartment, Rubber Grommet
7.
Locate the black wire harness
locking connectors between the brake
fluid reservoir and the air conditioning
compressor. Lift the blue connector
locks and disconnect the black
connector pair. See figure 4.
8.
Insert the male black connector
on the SpeedBrake harness into the
female black connector on the factory
harness. Insert the female black
connector on the SpeedBrake harness
onto the male black connector of the
factory harness.
Note: If vehicle is equipped with a
Banks tuner, disconnect the black
connectors between the factory
and the Banks tuner connection. It
is not important if the intercepting
connection is made before the Banks
tuner connection or after. this will
not affect the performance of the
Banks tuner or SpeedBrake. Insert
the male black connector on the
SpeedBrake harness into the female
black connector on the factory harness
or Banks tuner’s harness. Insert
the female black connector on the
SpeedBrake harness onto the male
black connector of the factory harness
or Banks tuner’s.
9.
Attach the Ground ring Terminal
to an existing bolt on the firewall
by removing the existing nut and
sliding the ring terminal over the bolt.
Re-install the nut and tighten to 80
lb-in. See figure 4.
Note: Make sure your ground
location is clean from dirt, grease and
corrosion or the Banks SpeedBrake
may not function properly.