For vehicles equipped with a factory filter minder – Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Ram-Air Intake System '07-10 User Manual
Page 13
96497 v.7.0
13
Note: the compressor supply and
return lines may need to be slightly
bent away from Banks air housing
to provide clearance. Be careful not
to break the condenser lines when
adjusting clearance. See Figure 11.
17.
Fasten the Banks air filter housing
to the well-nuts by tightening the
supplied 3⁄8 bolt and washer until
snug. Tighten the air housing bracket
nut to the radiator core support.
Tighten the bracket to the air housing
using an open-end wrench. See
Figure 12.
18.
connect the Banks hose to the
Banks inlet tube and tighten hose
clamp.
Note: ensure Banks hose is up to and
touching the raised bead on the Banks
intake tube. See Figure 13.
19.
Install second hose clamp and
leave loose.
20.
Install Banks intake hose and
intake tube to the compressor inlet.
Note: ensure hose is flush against
step on compressor inlet. Hand tighten
the hose clamp. See Figure 13.
21.
Place Banks air filter cover onto
the Banks air filter housing.
22.
Align intake tube with cover, and
then tighten the hose clamp on turbo
compressor inlet. See Figure 14.
Note: to provide additional clearence
straighten the negative battery harness
under the intake tube so that they lay
flat and loose under the intake.
23.
Locate the supplied PcV hose
and insert one end into the intake
tube. Insert the other end into the PcV
tube. Make sure the hose is properly
inserted.
For vehicles equipped with
a factory Filter Minder
24.
Remove factory filter minder from
factory air housing. Remove rubber
grommet from factory air housing.
Figure 14