All vehicles – Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Ram-Air Intake System '07-10 User Manual
Page 16
16
96497 v.7.0
25.
Install factory filter minder rubber
grommet into the Banks cover. Insert
the factory filter minder into rubber
grommet.
All Vehicles
26.
Remove cover from housing.
Install Banks bellows with hose clamps
to Banks Intake tube.
27.
Loosely install the hose clamp to
the Banks air filter.
28.
Install Banks air filter onto the
Banks cover. Note the audible snap.
Tighten the hose clamp on the air
filter. Make sure the air filter is lined
up with the alignment groove. See
Figure 15.
29.
Insert the Banks cover into the
Banks bellows. Place cover on to
housing and tighten the hose clamp.
See Figure 16.
30.
Using supplied screws fasten the
banks cover to the air filter housing.
31.
Remove the stock IAT and MAF
sensors from the factory air housing.
32.
Install IAT sensor into Banks cover
using supplied 6⁄32 screws. Locate
the supplied MAF gasket and install
over MAF sensor. Install MAF sensor
and gasket into the Banks intake tube
using the supplied 6⁄32 screws. See
Figure 17.
Note: ensure that o-rings are in good
condition.
33.
connect the IAT and MAF
connector to the IAT and MAF sensor.
Note: For added length in the IAt and
MAF sensor wires, seperate the two
wire bundles by CAReFULLY removing
the tape holding them together. See
Figure 19. Route harness away from
the exhaust manifold heat shield.
34.
Re-connect battery grounds.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 18. Make
sure to go over all hose clamps for
tightness and connectors for a sure fit.
Make sure that the intake tube is not
touching any engine components.
Figure 19