Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Ram-Air Intake System '07-10 User Manual
Page 6
6
96497 v.7.0
Use the Bill of Materials chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Remove the nut and washer from
radiator core support that secures the
factory air housing and set aside. See
Figure 2.
2.
Loosen the hose clamp to the
stock intake tube attached to the air
housing.
3.
Press tabs and remove the Intake
Air Temperature (IAT) and the Mass Air
Flow (MAF) connector sensor.
Note: Separate the IAt and MAF wire
harness from the negative battery
wire harness to provide addition wire
length. Secure away from the battery.
4.
Remove the air housing by lifting up
and out of the engine compartment.
Note: there may be slight resistance
when removing the air housing feet
due to rubber grommets.
5.
Remove the factory stock rubber
grommets attached to the outside of
the battery tray bracket. See Figure 3.
6.
Loosen and remove the PcV hose
connected to the Intake tube. Loosen
the hose clamp, and then remove the
factory air intake tube connection
attached to the compressor inlet.
Note: Simultaneously lift up and
forward to remove the factory intake
assembly. See Figure 4.
Section 2
RAM-AIR INSTALLATIoN
Figure 2