Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Intake- Ram-Air Intake System '07-10 User Manual
Page 3
96497 v.7.0
3
Dear Customer,
If you have any questions
concerning the installation of
your Banks Ram-Air System,
please call our Technical Service
Hotline at (888) 839-2700
between 7:00 am and 5:00 pm
(PT). If you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at
(888) 839-5600.
Thank you.
1
1.
For ease of installation of your Banks
Ram-air intake system, familiarize
yourself with the procedure by reading
the entire manual before starting work.
2.
The exploded view of the Ram-Air
assembly (pages 4-5) provides only
general guidance. Refer to each step
and section diagram in this manual for
proper instruction.
3.
Throughout this manual, the left side
of the vehicle refers to the driver’s side,
and the right-side to the passenger’s
side.
4.
Disconnect the ground cable from the
battery before beginning work. If there
are two batteries, disconnect both.
5.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more is
recommended where possible.
6.
During installation, keep the work
area clean. If foreign debris is transferred
to any Banks system component, clean it
thoroughly before installing.
7.
When raising the vehicle, support it
on properly weight-rated safety stands,
ramps or a commercial hoist. Follow the
manufacturer’s safety precautions. Take
care to balance the vehicle to prevent
it from slipping or falling. When using
ramps, be sure the front wheels are
centered squarely on the topsides; put
the transmission in park; set the parking
brake; and place blocks behind the rear
wheels.
CAuTIoN! Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry
or any other item not intended
specifically for this use.
Notification
The Banks Ram-Air Filter comes
pre-oiled and no oiling is necessary
for initial installation. Service the
filter as specified in the Filter
maintenance Section of this
manual.
Tools Required:
• 3⁄8” drive ratchets with metric
sockets
• Standard and Phillips head
screwdrivers
• Standard and needle-nose pliers
• Clean shop towels or rags
• 5⁄16 nut driver
• Hack Saw
• Ruler
General Installation Practices
Table of Contents
Section 1 . . . . . . . . . . . . . . . . . . . . . . 4
General Assembly
Section 2 . . . . . . . . . . . . . . . . . . . . . . 6
Ram-Air Installation
Section 3 . . . . . . . . . . . . . . . . . . . . . 18
Filter Maintenance