Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit (non-cat) '99-03 F250_F350 Trucks & Excursions - Manual (Page 10)

11.
locate the 7” x 24” blanket heat
shield provided. Form the heat shield
to the shape of the banks Monster
t.o.p. (turbine outlet pipe) in the
vertical section of the pipe. secure
the heat shield to the t.o.p. using the
wire ties provided (see Figure 4).
12.
reusing the saved V-band clamp
previously put aside, loosely clamp
the upper portion of the turbine
outlet pipe to the factory warm-up
valve outlet. Do not tighten at this
time.
NOTE: On some Power Strokes a
ground strap is bolted on the back
of the cylinder head. This bolt may
interfere with the Banks turbine
outlet pipe. If so, remove the bolt and
relocate it in the cylinder head.
13.
On 2002-03 F-series models
only, it is necessary to relocate the
factory-installed frame-mounted
hanger pin that is located behind the
transmission crossmember.
Figure 5
Figure 4
10
96335 v.6.0