Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit (non-cat) '99-03 F250_F350 Trucks & Excursions - Manual (Page 12)

18.
slip the 5” Monster tailpipe tip
on with the drain hole facing down
and banks logo facing up. Keep the
wrapping on for now. For a Fleet-side
truck the 5” tip should be hung 1” past
the end of the tailpipe. For a dually,
the tip should be 3 1 ⁄ 2 ” past the end of
the tail pipe. snug up the clamp.
19
position all the exhaust
components such that all the hanger
pins are parallel with the frame pins
and all exhaust tubing is located
properly. lightly tighten the clamps
to maintain position. the tailpipe tip
should be positioned 1-1 1 ⁄ 2 ” below
the bottom edge of the fender. all
hangers should be hanging slightly
forward to allow for heat expansion
of the exhaust tubing (see Figure 7).
20.
with everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
torque V-band clamp to 80 in-lbs.
torque all remaining clamps to 35
ft-lbs.
21.
For Excursions only: locate the
6” x 7” blanket heat shield provided
and wrap it around the brake cable
directly under the tail pipe hoop.
secure with wire tie provided. using
a pair of channel locks or vice grips,
gently bend the corner of the shield
that is attached to rear end on the
passenger’s side (see Figure 8).
22.
the 2-pin warm-up valve module
needs to be installed onto the warm-
up valve connector on the vehicle wire
harness. on the pedal stool under the
turbocharger, disconnect the 2-pin
connector. attach the 2-pin connector
to the banks warm-up valve module
and zip-tie the module and wire
harness away from any moving parts.
See Figure 9.
23.
your system includes two banks
power logos that have been designed
to compliment the Ford badging
on your truck. we have provided
measurements, which will allow you
to place these logos in a position
that gives a clean factory look. see
Figure 10.
24.
remove protective wrapping
from tailpipe tip. installation is now
complete.
Figure 8
Figure 9
12
96335 v.6.0