Banks Power Ford Trucks: (Diesel ’99 - 03 7.3L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit (non-cat) '99-03 F250_F350 Trucks & Excursions User Manual
Page 6
7.
remove the exhaust backpressure
control valve assembly from the
factory turbine housing by removing
the seven (12-point, 8mm head)
bolts. retain these bolts for reuse.
8.
install the banks power elbow
casting onto the outlet of the
turbocharger using the original
bolts. use the supplied anti-seize
compound on the bolts and tighten
them evenly. the torque specification
for these bolts is 62 in-lb (not Ft-lb!)
Note: It may be necessary to re-
locate the transmission dipstick tube
to allow clearance for the V-band
clamp at outlet of Power Elbow. The
tube can be re-located with a prybar
or similar tool. There should be
3
⁄
4
”-
1” clearance between the tube and
the Power Elbow casting.
9.
install the support bracket
between power elbow casting and
passenger-side cylinder head using
supplied
3
⁄
8
-16 x
3
⁄
4
” bolt, M10 x 1.5
x 20mm long bolt. see Figure 2. the
M10 x 1.5 x 20mm bolt is used on
the cylinder-head side of the bracket.
the
3
⁄
8
-16 x
3
⁄
4
” bolt is used on the
power elbow side of the bracket.
10.
Clamp the upper portion of the
supplied turbine outlet pipe onto the
outlet of the power elbow assembly
using the original turbine outlet
V-band clamp.
Note: If a pyrometer is used, the
probe may be installed in the
threaded port, located in the side of
the Power Elbow casting. Remove
the plug and install the probe using
the anti-seize provided.
If Power Elbow is being installed, skip
to step 13.
Figure 2
6
96335 v.6.0