Grain Systems Tanks PNEG-4075 - Manual (Page 67)

7
Roof Assembly
Topics Covered in this Chapter
▪ Attaching the Inside Stiffener to the Top Outside Stiffener
▪ Attaching the Eave Bracket to the Inside Stiffener
▪ Attaching the Eave Angle to the Sidewall Sheet
▪ Connecting the Tension Member to the Eave Bracket
▪ Attaching the Center Collar Rafter Clips to the Rafter
▪ About Temperature Cable Brackets and A-Frame Assemblies
▪ Assembling the Temperature Cable Bracket
▪ Attachment Locations of Purlins to Rafters
▪ Assembling Purlin Number 4
▪ Assembling Purlin Number 3
▪ Assembling Purlin Number 2
▪ Assembling Purlin Number 1
▪ Assembling a Double A-Frame
▪ Assembling the Center Collar
▪ Center Collar Placement
▪ Guidelines for Assembling and Lifting the A-Frame Rafter Sections
▪ Attaching the A-Frames to the Center Collar
▪ Attaching the A-Frame to the Eave Bracket
▪ Assembling the Roof Panel Clips
▪ Installing the 6–Hole Intermediate Purlins
▪ Installing the 4–Hole Intermediate Purlins
▪ Attaching the Roof Panels
▪ Installing the Roof Flashing
▪ Assemble and Install Center Collar Channels and Cap Plates
▪ Installing the Conveyor Support Brackets to the Peak Cap
Attaching the Inside Stiffener to the Top Outside Stiffener
The inside stiffener supports the eave bracket. It is installed to the inside perimeter of the sidewall sheet at
the same time as the top outside stiffener. Two-post sidewall sheets will have two inside stiffeners per
sheet and three-post sidewall sheets will have three inside stiffeners per sheet. The inside stiffeners are
only located at the eave bracket locations in the sidewall sheet.
What You Should Know
NOTE: Do not tighten the nuts (C) until all hardware has been installed attaching the inside stiffener (CTS–
2069XX) to the sidewall and the outside stiffener. Bins with an odd number of rings will use the
one-ring outside stiffener (CTS-2071XX), and bins with an even number of rings will use the two-
ring outside stiffener (CTS-2111XX or CTS-2116XX).
1. From the inside perimeter of the sidewall, place the bolt (B) through the hole located approximately 4
in. down from the top of the sidewall sheet (A).
Pneg-4075 75 Ft Diameter 40-Series Bin 67