Grain Systems Unload Augers PNEG-1058 - Manual (Page 16)

PNEG-1058
Sweep Tractor Assembly Instructions
16
Assembly
If installing sweep tractor to an existing sweep, the current end wheel
components must be removed.
1. Connect stub into flighting using a 5/8" x 4" long hex head capscrew and 5/8" nylon locknut.
2. Install bearing stand onto the stub shaft and bolt it to the sweep shield using a 3/8" x 3" hex
head capscrew, a 3/8" x 3" long carriage bolt, flatwasher, and nylon locknut.
3. Install the end wheel and collar onto the end of the stub shaft. Lock the collar in place with a
1/2" x 3-1/2" long hex head capscrew and 1/2" nylon locknut.
B. End Wheel Assembly
Sweep Shield
Sweep Flight
Stub Shaft
Bearing Stand
Weldment
End Wheel
Collar
FIG. 2
End Wheel Assembly