Grain Systems Unload Augers PNEG-1058 - Manual (Page 17)

Sweep Tractor Assembly Instructions
PNEG -1058 17
Assembly
1. Position sweep tractor against the sweep shield approximately 3' from the end wheel.
2. Use the bracket on the sweep tractor to mark the location where the holes need to be drilled into
the sweep shield. You may need to adjust the bolts on the sweep tractor bracket to match the
same height and angle on the sweep shield.
3. After marking the hole location, drill four (4) 7/16" holes and then attach the sweep tractor to
shield using (4) 3/8" x 1" hex head capscrews, (4) flatwashers, and four (4) 3/8" nylon locknuts.
4. Install electric wiring for motor and controls.
5. Run wiring for motor forward to the sweep shield along sweep mount tube. Attach the wiring to
the mount sufficiently to keep wiring from contacting sweep tractor wheels.
6. Attach the wiring to the sweep shield and run to the center of the bin.
7. At the center of the bin, the wiring may either be connected with the sweep flight motor or a
separate wire may be ran to the outside of the bin. If the wiring is connected to the wiring of the
sweep flight motor, then the tractor will turn on and off the sweep. If a separate wire is ran to the
outside of the bin, the sweep tractor can operate independently from the sweep.
C. Sweep Tractor to Shield Assembly
All electrical wiring shall be installed by a qualified electrician and must meet
the standards set by the National Electric Code and all local and state codes.
Sweep Shield
Adjustment bolts for adjusting the
angle and height of the bracket
(3/8" x 1" HHCS with flat
washer’s Nylon Locknut)
FIG. 4
Shield to Tractor Assembly