Grain Systems Bin Accessories PNEG-1742 - Manual (Page 15)

4. Assembly Instructions
PNEG-1742 VTDL-48 - 8 x 9 Door Assembly 15
15. To open the door, unbolt the door panels from the door frame. Do not remove the hinges or unbolt
the door panels from one another. Swing the door panels open to remove the center column.
Provisions should be made to hold the door panels open while the center column is being removed
and the bin is being cleaned. Unbolt the top of the center column from the header beam and remove
the shim plate. Slide the center column section inside off the threshold weldment, tilt outward
and then remove. Please be aware that the center column is extremely heavy and proper
equipment should be used for removal. Temporary ramps should be made to avoid driving over
the door panel attachment plates of the threshold weldment. Once the bin is fully emptied, re-install
the center column section, close the door panels and bolt the panels to the door frame. It may be
necessary to re-seal around the door panels and column weldments. Inspect all decals each time the
door is opened and replace if damaged or missing.