Grain Systems PNEG-1263 - Manual (Page 23)

23
2002 Top Dry Service School
Programming Set-up Variables
• Turn the Control Power “ off “
• Turn the Control Power switch “ on “
with the Program Temperature switch
held down.
• Press the Increase switch until 3 is on
the display.
• Press the Program Temperature switch
again.
• C or no C will bill displayed.
• Use the Increase or Decrease switch to
toggle between C or no C.
C - Hi-Lo cycling heater
no C - On/Off cycling heater
• When the correct selection is on the
screen press the Program Tempera-
ture switch again.
• H or no H will be displayed.
• Use the Increase or Decrease switch to
toggle between H or no H.
H - Humidity sensor present
no H - No humidity sensor
present
• When the correct selection is on the
screen press the Program Temperature
switch again.
• F or C will be displayed.
• Use the Increase or Decrease switch to
toggle between F or C.
F - Temperatures displayed in
Fahren- heit.
C-Temperatures displayed in
Celsius.
• When the correct selection is on the
screen press the Program Temperature
switch again.
• L or no L will be displayed.
• Use the Increase or Decrease switch
to toggle between L or no L.
L - The dryer will advance to
the Cool cycle when the Dry
timer has reached zero and the
Grain temperature set point
has been met.
noL - The dryer will advance
to the Cool cycle when either
the Dry timer has reached zero
or the Grain temperature set
point has been met.
• When the correct selection is on the
screen press the Program Temperature
switch again.
Series 2000 Batch Fan / Heater
Software Diagnostics