Grain Systems PNEG-1263 - Manual (Page 26)

2002 Top Dry Service School
26
Diagnostic Mode
• Turn the Control Power “ off “.
• Hold down the Program Tempera-
ture switch.
• Turn the Control Power switch “on “
with the Program Temperature switch
held down.
• Press the Program Dry time switch to
engage the Fan Starter.
• Press the Program Temperature switch
to start theIgnitor.
• Press the Hours x 1000 switch to open
the Ssolenoid.
• Turn the control power “off” to exit
the Diagnostic mode.
CAUTION: DO NOT ATTEMPT BELOW PROCEDURE WITH GAS LINE CONNECTED.
Series 2000 Autoflow Fan / Heater
Software Diagnostics