Chapter 7: roof assembly – Grain Systems Tanks PNEG-4054A User Manual
Page 106
Advertising
NOTE: Ensure that the orientation of the roof panel clip is correct, roof panel holes facing the roof
and the notch in the roof panel clip is facing the right-hand roof rafter.
3. Tighten all hardware to the recommended torque specifications only after the roof panels are
installed. See
Bolt Torque Specifications, page 28
Figure 7-24 Roof panel clip
A
Left-hand roof rafter (CTR-0582)
D
7/16 x 1-1/4 in. flange bolt (S-10250)
B
Roof panel clip (CTR-0410)
E
7/16 in. flange nut (S-10251)
C
Right-hand roof rafter (CTR-0582)
After You Finish
Repeat this procedure for the remaining roof panel clips.
106
Pneg-4054A 54 Ft Diameter 40-Series Bin
Advertising