Grain Systems Tanks PNEG-1093 User Manual
Page 50
6. Installation
50
PNEG-1093 2.66" Corrugation Unstiffened Bin
Safety Cage Bell Sections (24" or 48")
Attach the vertical supports to the hoop half assembly from the final safety cage installation using
5/16" x 3/4" bolts and nuts (with the heads on the inside of the cage). Assemble the special bell safety
cage hoop halves and attach to other end of vertical supports. The vertical support will have to be bent at
the flat area to allow for the angle of the bell section. Attach the safety cage brackets to the ladder as
shown
. Once the safety cage brackets are installed, attach the bell safety cage hoop half
assembly to the safety cage brackets and tighten bolts.
NOTE: The safety cage bell section is to be used at the point of termination of the safety cage and should
be just above the concrete (generally 7'-8').
Figure 6T