The cluster flux back panel – Moog Music MF-108M Cluster Flux User Manual
Page 12
12
LFO AMOUNT - Sets the overall amount of modulation of the delay time
by the LFO.
Note: As the LFO Amount increases, the functional range of the Delay Time control
is decreased, so that the maximum and minimum delay times are not exceeded.
BYPASS - Used to turn the Effect On and Off. When the effect is On, the
Bypass LED is Green. When the effect is Off, the Bypass LED is Red.
TAP TEMPO - Dedicated switch used for setting the LFO Rate to a musical
tempo. To initiate Tap Tempo control of the LFO, press the Tap Tempo switch
three times with the tempo you want (1/4 notes). On the third press, the
LFO Rate LED will change to Green, and the LFO will change rates to match
the timing of the switch presses. If you continue to press the Tap Tempo
switch, the LFO Rate will be set by a running average of the time between
switch presses. To start over, wait five seconds and then press the Tap
tempo switch three times to set a new tempo. To revert the unit to Panel
control, simply move the LFO Rate control. The LFO Rate LED will light up
Red, and the LFO will set by the panel control.
Note: When the LFO is synchronized to MIDI Clock messages, Tap Tempo is disabled.
MIDI INDICATOR LED - Lights up Red when the unit receives a MIDI message.
Un-implemented MIDI messages do not light up the MIDI LED.
THE CLUSTER FLUX BACK PANEL
AUDIO IN - 1⁄4” unbalanced audio input. The Cluster Flux accepts signals
from Instrument to line-level.
L/MONO OUT - 1⁄4” unbalanced audio output. When the effect is on, this
output carries the Dry and Wet signal blend set on the front panel Mix
control. The level is determined by the Drive and Output Level controls.
Note: The phase of the Wet signal is not inverted in relation to the Dry signal.
When the effect is off, the input signal passes only through a high-quality buffer on
its way to the output.
R OUT - 1⁄4” unbalanced audio output. This output can be used as a second
MIDI IN
FB INSERT
AUDIO IN
L/MONO OUT
R OUT
TIME
FEEDBACK
MIX
+9V
300 mA
LFO RATE
LFO AMT