Output configuration – Moog Music MF-108M Cluster Flux User Manual
Page 18
18
OUTPUT CONFIGURATION
The Right Output of the Cluster Flux is shipped from the factory having a Mix
of Dry signal and phase inverted Wet signal from the output of the BBDs. This
is so the Left and Right outputs can be panned hard left and right for a very
nice stereo effect. The Right output can be configured in other ways with the
DIP switches located on the Circuit board of the unit.
Any damage that occurs to the unit while changing the configuration from
the factory setting is not covered under the Warranty.
The bottom of the unit can be taken off by removing the four screws and
rubber feet. The Output DIP Switch offers four configurations as illustrated
DEFAULT OUTPUT CONFIGURATION: RIGHT OUTPUT & MIX ENABLED;
WET SIGNAL OUT OF PHASE
RIGHT OUTPUT & MIX ENABLED; DRY SIGNAL OUT OF PHASE
RIGHT OUTPUT DRY & MIX DISABLED; WET SIGNAL IN PHASE
RIGHT OUTPUT DRY & MIX DISABLED; WET SIGNAL OUT OF PHASE
Note: Do not set the Output configuration switch to any settings other than these
6
5
4
3
2
1
6
5
4
3
2
1
6
5
4
3
2
1
6
5
4
3
2
1