Moog Music MF-108M Cluster Flux - Manual (Page 19)

WARRANTY AND SERVICE INFO
LIMITED WARRANTY
Moog Music warrants that its products will be free from defects in materials
or workmanship, and shall conform to specifications current at the time of
shipment, for a period of one year from date of purchase. During the one year
period, any defective products will be repaired or replaced, at Moog Music’s
option, on a return-to-factory basis. This Warranty covers defects that Moog
Music determines are no fault of the user.
RETURNING YOUR MF-108M FOR REPLACEMENT/REPAIR
You must obtain prior approval and an RMA number from Moog Music before
returning any product to us. Wrap your MF-108M carefully and pack it with
the power adapter in its original carton.
The warranty will not be honored if the product is not properly packed.
Send it to Moog Music with transportation and insurance charges paid.
A reasonable cost for service, materials and return freight will be charged
to replace materials defective through the fault of the user, or for which the
one year warranty period has expired.
Transportation and insurance charges from Moog Music to your United
States address, of products repaired or replaced under warranty will be
paid by Moog Music.
APPENDIX: SPECIFICATIONS
The Cluster Flux is a 100% analog signal path delay device with two NOS, high
voltage BBDs tuned for optimum response in the Chorus and Flange times. It
features extensive time modulation and MIDI capabilities.
FRONT PANEL
•TIME: Adjust delay time 0.6mS to 10mS in Flange mode and 5mS to 50mS
in Chorus mode.
• RANGE: Select between Flanger and Chorus mode
• FEEDBACK: Continuous control from no feedback to infinite feedback.
Bi-Polar control allows the feedback to highlight even or odd harmonics.
• DRIVE: Allows between -7dB and +28dB of gain or attenuation of the input
signal for optimum signal path, level matching and distortion sounds.
• OUTPUT: Allows gain and attenuation of output signal for compatibility with
a wide range of input devices.
• MIX: Cross fader control to vary the amount of wet or dry signal heard on output.
• LFO: Six position rotary switch to select the LFO wave shape for delay
time modulation. Select between Sine, Triangle, Square, Ramp, Saw and
Random stepped modulation.
• LFO RATE: Adjust the LFO rate from the sub audio to audio rates. Control
from 0.05 Hz to 50 Hz from the front panel (more from the CV).
• LFO AMOUNT: Controls the amount of LFO modulation of the delay time.