Cobalt Digital FUSION 3G 9921-FS 3G_HD_SD Frame Sync - Manual (Page 97)

9921-FS-OM (V1.15) 9921-FS PRODUCT MANUAL 3-45
Operating Instructions
9921-FS Function Submenu List and Descriptions
(continued)
• Loudness-Processed Channels as
Source for AES Channel Output
LP51 L thru LP51 Rs (5.1-channel loudness processor processed channels
L thru Rs) range in Source drop-down list routes a loudness-processed
channel to be the source for the selected AES output channel.
(In this example, loudness-processed channel LP51 L is the source for
destination AES output Ch 1)
Note: Where stereo loudness processor is available, drop-down selections
for these channels are LP2 L and LP2 R.
• Tone as Source for AES Channel
Output
Tone 50 Hz thru Tone 16 kHz range in Source drop-down list routes one of
eight tone frequencies to be the source for the selected embedded output
channel.
(In this example, 50 Hz tone is the source for destination AES output Ch 1)
• Dolby ® Encoder Output as Source for
AES Channel Output
Encoded Dolby (L) and Encoded Dolby (R) selection in Source drop-down
list routes a Dolby encoded pair from any of the card’s Dolby encoders (A up
to D) to be the source for the selected AES output channel.
(In this example, Dolby Digital Encoder B (L) is the source for destination
AES output Ch 1)
Note: Encoded channel pairs selected should only be applied to companion
intact pairs (e.g., signals can be applied to AES pair
1/2, or AES pair 3/4 and so on, but not split to route through fabricated
unrelated pairs such as AES ch 2/ch 3).
• Silence as Source for AES Channel
Output
Silence selection in Source drop-down list mutes the selected AES output
channel. Use this setting for any unused AES output channels.
(In this example, Silence is the source for destination Embedded output Ch
1)
Note: If an AES pair is being used as an input, the channels do not have be
muted here.
• Gain / Mute Control Provides relative gain (in dB) control and peak level display for
corresponding AES output channel.
Also provides a channel Mute checkbox.
(-80 to +20 dB range in 0.1 dB steps; unity = 0.0 dB)
Table 3-2 9921-FS Function Submenu List — continued
•
•
•
•
•
•