Cobalt Digital FUSION 3G 9985 3G_HD_SD Loudness Processor - Manual (Page 100)

3
9985 Function Submenu List and Descriptions
3-48 9985 PRODUCT MANUAL 9985-OM (V1.18)
(continued)
Shown below are the Custom Preset sub-tab parametric controls corresponding to A thru H on the previous page. Non-standard
controls and unique functions are described below.
• Parametric EQ 1 thru 3: Provides 3 bands to provide notch filters. Default set to 0 dB (no effect). Each filter has a ±12 dB
gain
control, and selectable center frequencies from 20 Hz – 22.05 kHz.
• Inf:>1Thr checkboxes: When enabled, automatically increases AGC ratio to Infinity:1 once a signal exceeds the AGC threshold,
allowing for expansion below the threshold and limiting above the threshold. Useful for bass frequency control.
• Soft Clip controls: For low-frequency bands 1 and 2, sets the point above in which band 1 (low bass) and band 2 (mid bass) are
very quickly limited, acting more like a clipper without the artifacts. This helps maintain a “tight” bass sound.
Applying and Saving Custom Presets
Note: Presets are engaged on the Channel Mapping sub-tab page. The Presets drop-down on this page only populate the
fields here with the defaults used for a particular preset profile.
1. In Presets drop-down on the Channel Mapping sub-tab page, select Custom.
2. On this sub-tab page, select the default preset to “build from” (i.e., preset closest to desired custom) and press Load Template.
The fields here are now populated with the detailed default settings for the selected default preset profile.
3. Perform parametric changes as desired. Listen to material and assess changes performed.
Note: Any changes made on this page are saved using card global presets and not locally on this page.
4. Save the custom settings in accordance with Presets tab instructions in Chapter 3. Operating Instructions of the card’s product
manual.
Table 3-2 9985 Function Submenu List — continued
A
B
C
D
E
F
G
H