Cobalt Digital COMPASS 9215-EO-EM AES_EBU Fiber Audio Embedder - Manual (Page 17)

9215-EO-EM User Manual •••• (V 1.1) Installation •••• 2-3
Caution — Never attempt to look down the barrel of a connected fiber or device
transmitting an optical signal. The transmitted light is not in the visible spectrum and
may cause permanent eye damage. Turn off all laser sources before disconnecting
devices.
Rear Modules for the 9215-EO-EM
When installing the 9215-EO-EM in the 20-slot frame, the RM-20-9215-B Full Rear Module is
required. Refer to the section “8321 Series Frame Cabling Overview” for cable designations.
Installing a Rear Module
If the Rear Module is already installed, proceed to the section “Installing the 9215-EO-EM”.
Use the following procedure to install a Rear Module in your 20-slot frame:
1. Locate the card frame slots on the rear of the frame.
2. Remove the Blank Plate from the slot you have chosen for the 9215-EO-EM installation.
3. Remove the dust cap from the Fiber ports on the Rear Module that faces the interior of
the frame. Refer to Figure 2.1 and Figure 2.2 for dust cap locations.
Figure 2.2 Card Connectors Connectors with Dust Caps Removed
4. Install the bottom of the Rear Module in the Module Seating Slot at the base of the
frame’s back plane.
5. Align the top hole of the Rear Module with the screw on the top-edge of the frame back plane.
6. Using a Phillips screwdriver and the supplied screw, fasten the Rear Module to the back
plane of the frame. Do not over tighten.
7. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
Rear Modules or Blank Plates.
This completes the procedure for installing a Rear Module in the frame.
Installing the 9215-EO-EM
The 9215-EO-EM uses a single mode, LC/UPC connector to interface with the RM20-9215-B Full
Rear Module. This section outlines how to install the 9215-EO-EM in a frame.