Cobalt Digital COMPASS 9215-EO-EM AES_EBU Fiber Audio Embedder - Manual (Page 31)

9215-EO-EM User Manual •••• (V 1.1) Menus •••• 4-3
DashBoard Menus for the 9215-EO-EM
This section briefly summarizes the menus, items, and parameters available from the DashBoard
Control System™ for the 9215-EO-EM. Parameters marked with an asterisk (*) are the factory default
values.
The DashBoard Control System™ enables you to monitor and control openGear frames and cards from
a computer. DashBoard communicates with other cards in the 20-slot frame through the Network
Controller Card.
Status Tab
Table 4.1 summarizes the Status tab parameters available in DashBoard for the 9215-EO-EM.
Table 4.1 Status Tab Items
Menu Item Parameters Description
Product 9215-EO-EM
Supplier Cobalt Digital Inc.
Board Rev ##
Rear Module # Type of rear module in the slot
Board S/N ###### Indicates the card serial number
Software Rev ##.## Indicates the software version
Product
(Read-
only)
Firmware Rev #.### Indicates the firmware version
OK
FPGA load invalid
Incomp I/O Module
Current out of spec
Internal Error
SFP Temp Low
SFP Temp High
SFP Power High
SFP Power Low
SFP Tx Fault
HW Status
SFP Not Detected
Indicates the status of the hardware
including the SFP module. Some messages
displayed are dependent on the settings in
the Alarms Enable tab.
Voltage (mV) # Supply Voltage
Hardwar
e (Read-
only)
Current (mA) # Current consumption of card
Hardwar
e (Read-
only) Optical Module
Temperature (C)
#
Indicates the temperature of the Optical
Module