TC Electronic NDR-1 Nova Drive - Manual (Page 15)

15
EN
Parallel Routing:
The signal is processed in parallel by the two sections,
and they do not influence each other.
The selected routing is stored as part of each
preset.
19 – PRESET Number Display
NOVA Drive has 18 preset locations. The number of
the currently recalled preset is displayed in the 2x7-
segment display.
20 – PRESET Encoder / Store Button
This is a two-function button: Use it to select and store
presets.
To select and recall a preset: Simply turn the knob to
browse and select presets.
To store the current settings at a preset location:
First press and hold the encoder for two seconds to
activate the store function. If you just want to store the
preset at the current location, simply release the button
again. If you want to store the preset at a different
location, keep the encoder pressed and turn it to select
the new location, then release it.
21 – OVERDRIVE Switch
Use this switch either for switching NOVA Drive’s
overdrive section on/off (in Normal and Toggle Mode)
or for selecting the previous preset bank (in Bank
Mode).
22 – DISTORTION Switch
Use this switch either for switching NOVA Drive’s
distortion section on/off (in Normal and Toggle Mode)
or for selecting the next preset bank (in Bank Mode).
23 – STATUS LEDs
These LEDs indicate the status (on/off) for the two
sections of NOVA Drive.
OPERATION