Rainbow Electronics AT45DB161D - Manual (Page 34)

34
3500O–DFLASH–11/2012
AT45DB161D
Figure 21-1. RapidS Mode
21.6 Reset Timing
Note: The CS signal should be in the high state before the RESET signal is deasserted
SCK
MOSI
MISO
1
2 3 4 5 6 7
8 1
2 3 4 5 6 7
8
MOSI = Master Out, Slave In
MISO = Master In, Slave Out
The Master is the host controller and the Slave is the DataFlash
The Master always clocks data out on the rising edge of SCK and always clocks data in on the falling edge of SCK.
The Slave always clocks data out on the falling edge of SCK and always clocks data in on the rising edge of SCK.
A. Master clocks out first bit of BYTE-MOSI on the rising edge of SCK
B. Slave clocks in first bit of BYTE-MOSI on the next rising edge of SCK
C. Master clocks out second bit of BYTE-MOSI on the same rising edge of SCK
D. Last bit of BYTE-MOSI is clocked out from the Master
E. Last bit of BYTE-MOSI is clocked into the slave
F.
Slave clocks out first bit of BYTE-SO
G. Master clocks in first bit of BYTE-SO
H. Slave clocks out second bit of BYTE-SO
I.
Master clocks in last bit of BYTE-SO
A
B
C D
E
F
G
1
H BYTE-MOSI
MSB LSB
BYTE-SO
MSB LSB
Slave CS
I
CS
SCK
RESET
SO (OUTPUT)
HIGH IMPEDANCE HIGH IMPEDANCE
SI (INPUT)
tRST
tREC tCSS