Restriction in atmega161 compatibility mode, Overview, Atmega162/v – Rainbow Electronics ATmega162V User Manual

Page 105

Advertising
background image

105

ATmega162/V

2513E–AVR–09/03

16-bit Timer/Counter
(Timer/Counter1 and
Timer/Counter3)

The 16-bit Timer/Counter unit allows accurate program execution timing (event man-
agement), wave generation, and signal timing measurement. The main features are:
•

True 16-bit Design (i.e., allows 16-bit PWM)

•

Two Independent Output Compare Units

•

Double Buffered Output Compare Registers

•

One Input Capture Unit

•

Input Capture Noise Canceler

•

Clear Timer on Compare Match (Auto Reload)

•

Glitch-free, Phase Correct Pulse Width Modulator (PWM)

•

Variable PWM Period

•

Frequency Generator

•

External Event Counter

•

Eight Independent Interrupt Sources (TOV1, OCF1A, OCF1B, ICF1, TOV3, OCF3A, OCF3B,
and ICF3)

Restriction in
ATmega161
Compatibility Mode

Note that in ATmega161 compatibility mode, only one 16-bits Timer/Counter is available
(Timer/Counter1).

Overview

Most register and bit references in this section are written in general form. A lower case
“n” replaces the Timer/Counter number, and a lower case “x” replaces the Output Com-
pare unit channel. However, when using the register or bit defines in a program, the
precise form must be used i.e., TCNT1 for accessing Timer/Counter1 counter value and
so on.

A simplified block diagram of the 16-bit Timer/Counter is shown in Figure 46. For the
actual placement of I/O pins, refer to “Pinout ATmega162” on page 2. CPU accessible
I/O Registers, including I/O bits and I/O pins, are shown in bold. The device-specific I/O
Register and bit locations are listed in the “16-bit Timer/Counter Register Description”
on page 127.

Advertising