At+clvl=<vol><cr – Rainbow Electronics GM862-GPS User Manual
Page 23
GM862-GPS Software User Guide
1vv0300729 Rev. 5 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved
page 23 of 120
For example:
1 - Let's assume that the desired audio path is always the internal MT
Command:
AT#CAP=2<cr>
Answer:
OK
2 - Let's assume that the desired audio path has to be determined by HARDWARE pin AXE
Command:
AT#CAP=0<cr>
Answer:
OK
Now set the hardware pin AXE in the desired status.
2.6.1.3 Set the desired volume on the active audio path speaker output
This setting is not strictly necessary; it is also possible to keep the default volume setting.
•
Send command
AT+CLVL=<vol><cr>
where:
<vol> is a number between 0 and 10 representing the volume setting:
0 – minimum volume
10 - maximum volume
•
wait for
OK
response
NOTE: The volume setting refers to the ACTIVE path ear line and is stored each time. When
changing audio path the volume setting will be reset to the previously stored value for that
audio path.