BabyTrend INERTIA INFANT - Manual (Page 19)

35 36
10.0
Securing Car Seat in Your Vehicle
10.0
Securing Car Seat in Your Vehicle
• BASE MUST BE PROPERLY RECLINED. INFANTS UNDER 3
MONTHS OF AGE OR UNABLE TO HOLD THEIR HEAD UPRIGHT
UNASSISTED MUST USE RECLINE POSITION # 1.
• WHEN INSTALLING BASE WITH VEHICLE SEAT BELT, BELT
ADAPTER MUST BE USED AND POSITIONED BEHIND LAP BELT
ON BOTH SIDES.
10.3.1 Initial Positioning
1. Make sure the Belt Adapter is on
the LATCH Connectors. (Fig. 36-1)
2. If vehicle seat back is adjustable,
adjust into the upright position
or the position or the position
specified in the vehicle owner’s
manual for use with a Car Seat.
3. Place the Base in the rear-facing
position in a forward facing vehicle
seat with Belt Adapter contacting
vehicle seat back as shown in Fig.
36-2. Note: If brace contacts vehicle
seat back before Belt Adapter
contacts vehicle seat back, adjust
Brace into vertical position and then
place Base on vehicle seat with Belt
Adapter contacting vehicle seat back.
4. Adjust Base recline into desired recline position. (see Section 10.4)
To Remove Base
Disconnect LATCH Lower Connectors.
To disconnect the LATCH Connectors:
1. Push base toward LATCH connectors and while
pushing on the base, press the LATCH Release
Button on one of the LATCH Connectors (Fig 35-
1) and pull base away from the vehicle anchors.
2. Repeat on oppositie side.
3. Attach the Belt Adapter onto LATCH
Connectors when not in use.
10.3 Base Installation with Vehicle Belt
WARNING!
DEATH or SERIOUS INJURY can occur:
• FAILURE TO PROPERLY SECURE YOUR CHILD IN THE CHILD
RESTRAINT INCREASES THE RISK OF SERIOUS INJURY OR
DEATH IN THE EVENT OF A SHARP TURN, SUDDEN STOP
OR CRASH.
• VEHICLE LAP BELT MUST STAY TIGHTLY ADJUSTED TO CHILD
RESTRAINT AT ALL TIMES. IF VEHICLE BELT DOES NOT STAY
TIGHT, READ VEHICLE OWNER’S MANUAL AND “VEHICLE SEAT
BELT REQUIREMENTS” SECTION IN THIS MANUAL.
• FAILURE TO INSTALL CAR SEAT AT CORRECT SEAT RECLINE
ANGLE CAN CAUSE DEATH OR SERIOUS INJURY.
35-1
LATCH
relese button
36-2
36-1