Securing child with harness system – BabyTrend INERTIA INFANT User Manual

Page 25

Advertising
background image

47

48

5. The proper height of the harness straps is

at or just below your child’s shoulders.

(Fig 48-1) (see Section 11.2 Adjusting

Harness Strap Height)

6. Place harness straps over child’s shoulders

and put the two buckle tongues together,

overlaying the left buckle tongue onto the

right buckle tongue, and insert the two

joined buckle tongues into the harness

buckle until they click into place.

Note: Pull up on tongues to make sure that

BOTH tongues click into place. (Fig 48-2)

7. Check buckle height - The Crotch

Strap should be adjusted so that

a gap of 1/2” to 1” is present

between the ears of the buckle

and the top of child’s thigh (Fig

48-3), disregarding any clothing

or diaper. If buckle is too low or to

high, adjust height. (see Section

11.3 Adjusting Crotch Strap

Length)

1. Loosen built-in safety harness by

pressing the Harness Adjuster Button

and pulling the harness straps toward

you. (Fig 47-1)

2. Open Harness Clip by pressing button and

sliding apart. (Fig 47-2)

3. Unbuckle Harness Buckle by pressing

button and sliding buckle tongues up and

out of buckle. (Fig 47-3)

4. Place your child in the Car Seat so that

the child’s bottom is against the back and

bottom of the seat. (Fig. 47-4)

11.0

Securing Child with Harness System

11.0

Securing Child with Harness System

47-1

47-2

47-3

47-4

Correct

Incorrect

48-1

48-2

48-3

thigh

buckle

Advertising