American Car Craft Corvette Executive Series Fluid Cap Cover 5Pc Set - Carbon Fiber Chevy Bowtie 2005-2013 C6 Automatic User Manual
American car craft instructions
AMERICAN CAR CRAFT INSTRUCTIONS
CORVETTE BOWTIE CARBON FIBER ENGINE FLUID CAP COVER SET
Fits Automatic Models 1997-Current
PART #043096
Parts Included
___5-Chrome Cap Covers
___5-Attachment Cookies
___1-Pack Adhesive Promoter
Introduction: These new and unique caps are designed to set over the factory cap as a cosmetic cover only. These chrome plated
steel caps are simple to attach and offer a nice clean look.
1. The first step for installation will be to thoroughly scrub the tops of each of the factory caps, the oil/water/washer
fluid/brake fluid/power steering and clutch fluid if so equipped. Scrub them with alcohol to remove any surface
contaminants then swipe the tops with the adhesive promoter provided.
2. You have been provided with 2'' furry Velcro attachment cookies for each cap. Peel the release liner from the back of each
cookie and firmly set them to the top of each factory cap.
3. The factory wind shield washer fluid cap will need to be trimmed slightly in order for the new cover to sit nice and centered.
To do this, simply snip the finger tab as well as the attachment strap off the cap with a scissor.
4. The set will contain a cap cover that is angled for the oil cap and a thinner cover for the power steering cap. The remaining
covers in your kit are for all other factory caps. Simply set them in place.
If any questions or problems occur during installation, please contact American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520