American Car Craft Camaro A_C Vent Trim Polished Center Kit 3Pc 2010-2011 User Manual
Page 2
PLEASE NOTE:
Installation errors are NOT manufacturing defects and parts can
NOT be RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter packs/tubes
(provided) to wipe the areas of your dash/door that will be covered with your
new stainless pieces. Allow a few seconds to dry. You have been provided with
attachment tape test strips. Use one of these to test the tack. If it seams to
stick well then you can proceed with your installation. If you can not get the
test tape to stick please refer back to the special preparation instruction sheet
and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment place
each piece into position and check the fit and also get acquainted with just how
each part sets in place. It WILL be necessary to form a few of the parts by hand
to CONFORM to the shape of your dash to insure a nice perfect fit without
forcing the shape. Once you are satisfied with the shape and fit peel the red
release liner and firmly press each piece into position.
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good idea to
lightly dust your kit with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free
glass cleaner.
If any questions occur during installation please contact American Car Craft at
727-861-1500
Thank you and enjoy your purchase!
AMERICAN CAR CRAFT
18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520