American Car Craft Corvette Inner Fender Liners 4Pc with Top Caps Polished 1997-2004 C5 & Z06 User Manual
American Car Craft For the car

AMERICAN CAR CRAFT INSTRUCTION
C5
CORVETTE
4pc FENDER LINERS
PART # 033027
PARTS INCLUDED:
___4-Stainless Fender Liners
___10-Low Profile Phillips Fender Screws
___ 2-Adhesive Promoter Packs
These new and unique parts will be that final touch to finish off your custom engine bay
of your C5!
Your new liners come to you with a protective liner do not remove this liner until
installation is complete.
Scrub the two inner fender areas as well as the top of the fender ridge with alcohol to
remove any dirt and road grime. Then swipe the areas once with the adhesive promoter
provided.
Remove the factory screws from the top of both fenders and then replace them with the
lower profile Phillips screws provided. Doing this will create the clearance necessary for
the top fender caps. NOTE: If you are installing the C5 fender lighting kit slide the light
strip in between the fender ridge and the inner fender wall and line up all the holes. Run
the wire along the inner fender up to the battery box for the passenger side and all the
way up to the wiper cowl for the driver’s side. Remove the hood gasket and then route
that wire along to the battery box under the plastic wiper cowl and then replace the hood