American Car Craft Corvette Stingray Rear Valance Vent Grilles Laser Mesh 2Pc Polished 2014+ C7 - Manual

AMERICAN CAR CRAFT INSTRUCTIONS
C7 CORVETTE STINGRAY REAR VALANCE TRIM – POLISHED LASER MESH
PART #052003
PARTS INCLUDED:
2-REAR VALANCE GRILLES
1-ADHESIVE PROMOTER TUBE
GENERAL PART INSTALLATION INSTRUCTIONS
Introduction: In the next few paragraphs we will explain to you what you will need to know and do for a
successful application of ACC Stainless Steel Accessories. It is important to understand that almost all stainless
steel peel and stick accessories need to be pre shaped by hand in order to achieve a nice long term
installation. We realize that all parts are different from each other but as far as the installations of these parts
they all will need to follow the same set of general instructions.
Liner info: Your new accessories will come to you with a protective surface liner. Leave this liner in place until
the installation is complete to prevent finger prints and or possible scratches during installation. This liner is
required to remain on the part until you are instructed to remove it.
1. The first thing that needs to be done in any peel and stick application is surface preparation. It is
important that you examine the surface to determine if any kind of special treatments have ever been used.
Such as wax/silicone treatments and/or polymer surface preps. Take a strip of masking tape and press it very
firmly to make it adhere to the surface. Then peel it off to see how difficult it is to remove. If your masking
tape is removed extremely easy and/or does not stick at all then you will need to perform a special surface