American Car Craft Camaro Door Handle Pull Trim Brushed Interior 2Pc 2010-2012 User Manual
Page 2
PLEASE NOTE:
Installation errors are NOT manufacturing defects and parts
can NOT be RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter
packs/tubes (provided) to wipe the areas of your dash/door that will be
covered with your new stainless pieces. Allow a few seconds to dry. You
have been provided with attachment tape test strips. Use one of these to
test the tack. If it seams to stick well then you can proceed with your
installation. If you can not get the test tape to stick please refer back to
the special preparation instruction sheet and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment
place each piece into position and check the fit and also get acquainted
with just how each part sets in place. It WILL be necessary to form a few of
the parts by hand to CONFORM to the shape of your dash to insure a nice
perfect fit without forcing the shape. Once you are satisfied with the
shape and fit peel the red release liner and firmly press each piece into
position.
If any questions occur during installation please contact American Car Craft @
727 861-1500
Thank you and enjoy your purchase!
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good idea
to lightly dust your kit with a clean soft cloth first in order to prevent any
particles from scratching it. Then wipe (using a new clean soft cloth) with a
good quality streak free glass cleaner.
AMERICAN CAR CRAFT
18924 SAKERA ROAD HUDSON, FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520