American Car Craft Corvette Exhaust Filler Panel Corsa 3.5 Quad Tips Laser Mesh Polished 2005-2013 C6 User Manual
Page 4
however the valence is relatively soft and can be moved easily with one hand as you slip
on the grommet with the other.
4. Now that you have successfully made all adjustments you may now proceed with
the installation. Reposition the filler panel to check the adjustments.
5. Once you are satisfied with the fit of the filler panel pull the panel down away
from the bumper enough so that you can remove the red liner from the attachment
tape and press back into position firmly.
6. Using the 2 washer head screws (provided) locate the pre drilled holes in the
underside of the panel and install the screws. You have also been provided with 2
flat nuts. Reaching around to the underside of your new cover carefully twist the
flat nuts onto the washer head screws that you just installed. Hold the nut with
your fingertips as you turn the screw BY HAND with your Philips screwdriver
until snug. Be sure to finger the two or four flat nuts onto the screw tip before
turning the screw to prevent the flat nut from binding and possibly causing injury
to your finger tips. Do not over tighten. This will insure that your panel will
remain attached even at high driving speeds.
7. NOTE: The perforated panels come to you with a second set of holes and two
additional screws and flat nuts to be installed as in step 5 at the two forward
locations. CAUTION NOTE: These additional screws are provided to support the
additional weight of the perforated panel.
8. Remove protective liner.
If any questions occur during installation please contact American Car Craft at 727
861-1500. Note: Care must be taken when cleaning your panel. It is a good idea to
lightly dust your cover with a clean soft cloth first in order to prevent any particles
from scratching it. Then wipe using a new clean soft cloth with a good quality streak
free glass cleaner.
Thank you and enjoy your new purchase!