American Car Craft Dodge Charger _ Chrysler 300 Headlight _ Trunk Control Panel Trim Ring 2011-2013 User Manual
American car craft instructions, Very important

AMERICAN CAR CRAFT INSTRUCTIONS
Charger Dash Trim Ring 1pc Headlight/Trunk
PART #331014
Parts Included
1-Stainless Dash Trim Ring
1-Adhesive Promoter Tube
!!!!!VERY IMPORTANT!!!!!
BEFORE YOU BEGIN YOU MUST FIRST PREP YOUR DASH/DOOR AREAS WHERE PIECES ARE
GOING TO BE INSTALLED IN ORDER TO ALLOW ADHESION!!!!. You can do this by scrubbing the entire
area first with household isopropyl alcohol.
NOTE: If these areas have been treated with armor all or any such
surface protector; installation will NOT work unless these treatments have first been removed using special
chemicals. PLEASE REFER TO THE SPECIAL PREPARATION INSTRUCTION SHEET ENCLOSED.
We cannot be responsible for kits not sticking do to improper preparation!
PLEASE NOTE:
Installation errors are NOT manufacturing defects and
parts can NOT be RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter packs/tubes (provided) to wipe the
areas of your dash/door that will be covered with your new stainless pieces. Allow a few seconds to dry.