American Car Craft Corvette Air Dam Grilles Billet Polished 2006-2013 Z06+GS+ZR1 User Manual
Page 2
the left and right side of the vent hole under the air dam. NOTE: These screws
will not be reused.
2. You will notice that there are two holes on either side of the new grille. Line these
holes up with the screw locations you just exposed and fasten with the two long
black washer head screws provided. Simply place the screw thru the grille hole
then thru the brown spacers provided and snug down the grille at both locations.
NOTE: Be sure that the grille studs are facing down.
3. After you successfully installed the grille prepare the underside of the air dam by
wiping off any and all dirt in front of the grille opening using household rubbing
alcohol until clean. Then swipe the area once with the adhesive promoter
provided and attach the black air deflector by peeling the red release liner from
the plate then set in place pressing firmly along the tape area to set. Do not get
wet for 24 hours.
4. Repeat process for opposite side.
If you have any questions during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com