American Car Craft Hummer H2 Speaker Rings Polished Outer Door 4Pc 2003-2007 User Manual
Page 2
1. Once your areas have been prepared use the adhesive promoter packs/tubes
(provided) to wipe the areas of your dash/door that will be covered with your
new stainless pieces. Allow a few seconds to dry. You have been provided with
attachment tape test strips. Use one of these to test the tack. If it seems to
stick well then you can proceed with your installation. If you cannot get the
test tape to stick please refer back to the special preparation instruction sheet
and repeat those procedures.
2. Before you remove the liner for permanent attachment place each piece into
position and check the fit and also get acquainted with just how each part sets in
place. It WILL be necessary to form a few of the parts by hand to CONFORM to
the shape of your dash to insure a nice perfect fit without forcing the shape.
Once you are satisfied with the shape and fit peel the red release liner and firmly
press each piece into position.
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good idea to
lightly dust your kit with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free
glass cleaner.
If any questions or problems occur during installation, please contact American Car
Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520