American Car Craft Chrysler 300 _ Dodge Charger_Magnum 5.7 SRT 8 Fuse Box Cover Polished 2005-2010 - Manual (Page 2)

1. Clean the entire top of the factory fuse box first with soap and water to remove
any dirt and grime then scrub it with household rubbing alcohol until it is
completely clean. Swipe the entire area you just cleaned with the adhesive
promoter provided.
2. You have been provided with 4 Velcro attachment cookies. Swipe the underside
of your new stainless fuse box cover with the adhesive promoter provided. Peel
the release liner off of one side of these cookies and place them on each corner
of the underside of the fuse box cover and press firmly on them to set. Then pull
the release liner off of the top half of all the cookies. Place your new cover into
position and press firmly over the entire cover to make sure all of the cookies
make contact.
Tech Note: Depending on the year of the vehicle it may be necessary to remove the
red post cover as well as lowering the extra height of the metal post itself. This can
by done by simply snipping off any excess with a pair of bolt cutters. This will
prevent any possibility of the bolt coming in contact with the new cover. It also may
be necessary to reposition the windshield washer tube and tuck the line under the
fender ridge rerouting the line in order to allow a nice placement of the new cover.
3. Remove protective liner.
If any questions occur during installation, please contact American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!
Note: Care must be taken when cleaning your cover. It is a good idea to lightly dust
your cover with a clean soft cloth first in order to prevent any particles from
scratching it. Then wipe (using a new clean soft cloth) with a good quality streak free
glass cleaner.