American Car Craft Mustang Door Panel Inserts Brushed Without Padded Door 2pc V6 & GT 2005-2009 - Manual (Page 2)

1. Your new door panel insert is designed to permanently stick to your door panel
via 3M Super Attachment Tape and is very reliable however if this area has been
treated with armor all or any silicon based treatments this installation will not
work unless special chemicals and procedures are followed. Please refer to the
SPECIAL INSTRUCTIONS ATTACHED.
2. Scrub the top of the door pull area with household rubbing alcohol to prepare the
surface. Once this is done use the adhesive promoter (provided) to wipe the entire
area to be covered with your new door panel. NOTE: Be careful not to apply any
excess adhesive promoter anywhere outside of the area where you will be
mounting your new kit as this will leave a mark on your door panel. Allow a few
seconds to dry. You have been provided with attachment tape test strips. Use
one of these to test the tack. If it seams to stick well then you can proceed
with your installation. If you can not get the test tape to stick please refer
back to the special preparation instruction sheet and repeat those
procedures.
3. Before permanently attaching place the upper insert in position to check the fit
and to get acquainted with just how it installs. You will notice a small notch area
to be inserted into the arm rest if installed correctly it should sit nice and tight to
the arm rest panel leaving no gaps. Once you are clear about how it sits peel the
red release liner and press the panel firmly in place.
4. You have been provided with a length of chrome trim and a tube applicator of
adhesive promoter. Squeeze the tube to break the fluid capsule and apply a thin
swipe directly to the outer edge of the DOOR PANEL AROUND the panel insert
you just installed.
5. Peel a small length of the red release liner from one end of the chrome trim and
firmly press it directly to the door panel peeling the liner as you go and making
sure that the trim rests tightly against the edge of the panel insert. Work your way
to the end and cut away any excess trim.
6. Repeat process for opposite side.