American Car Craft Hummer H2 AC Surround Ring Polished 2003-2007 User Manual
Page 2
1. Once your areas have been prepared use the adhesive promoter
packs/tubes (provided) to wipe the areas of your dash/door that will be
covered with your new stainless pieces. Allow a few seconds to dry. You
have been provided with attachment tape test strips. Use one of
these to test the tack. If it seems to stick well then you can proceed
with your installation. If you cannot get the test tape to stick please
refer back to the special preparation instruction sheet and repeat
those procedures.
2. Before you remove the liner for permanent attachment place each piece
into position and check the fit and also get acquainted with just how each
part sets in place. It WILL be necessary to form a few of the parts by hand
to CONFORM to the shape of your dash to insure a nice perfect fit without
forcing the shape. Once you are satisfied with the shape and fit peel the
red release liner and firmly press each piece into position.
Note: EXTRA CARE must be taken when cleaning your dash kit. It is a good
idea to lightly dust your kit with a clean soft cloth first in order to prevent
any particles from scratching it. Then wipe (using a new clean soft cloth)
with a good quality streak free glass cleaner.
If any questions or problems occur during installation, please contact
American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520