American Car Craft Corvette Headlight Buckets 2Pc Deluxe Polished 1997-2004 C5 & Z06 User Manual
Page 2
type screws. Remove the protective liner from the new cover and then simply set the new cover and
align the holes at the side of the headlight and snug these down. Be careful not to over tighten these
screws as this will cause an unsightly warp in the new panel. Just snug will work fine. Once you have
the two side screws set place the two longer screws in place at the back two holes and line up the screw
with the two holes and snug these down as well. A properly installed cover will conform nicely around
the headlight and allow proper up and down function. It should also have sufficient clearances on the
headlight motor as to not allow any binding against the headlight motor.
If you have any questions please call American Car Craft.
Thank you!
American Car Craft LLC
18924 Sakera Rd Hudson, FL. 34667
Ph 727.861.1500 Fax 727.861.1520