American Car Craft Dodge Challenger Grille Overlay Style Upper Main Polished 2008-2013 - Manual (Page 2)

5. You have been provided with a length of chrome trim. Peel a small length of the red
release liner from one end of the trim then start at the top dead center of the grille place
one end of the trim directly to the paint but tight against the grille overlay you just
installed. Pull the red release liner as you work your way around the edge of the grille
until you reach the start point. Cut away the excess trim with a scissor so that you will be
able to press the end into a nice tight butt seam. TECH TIP: This trim will have a
tendency to shrink over time so in order to counter act this you need to forcibly push the
trim into each corner so as to actually stuff the trim into the corners then add a little drop
of instant adhesive to the end of the trim as you set the butt seam. Use a little nail polish
remover if you get a little glue mess.
6. After the grille has been successfully installed remove the protective liner and simply
snap the factory emblems back in place.
NOTE: The lower grille section will install in exactly the same way as the top section only there are no
emblems to replace. The lower grille section has been designed as a brushed part so as to allow the grille to
be seen. Since the factory grille faces slightly downward a polished grille will simply disappear in its
reflection so a brushed grille has been created to compensate for this problem.
AMERICAN CAR CRAFT 18924 SAKERA ROAD-HUDSON FLORIDA 34667
Phone # 727-861-1500 Fax # 727-861-1520 www.americancarcraft.com