American Car Craft Camaro Fuel Rail Covers Perforated "SS Style Illuminated 2010-2013" - Manual (Page 2)

1. You will notice two exposed holes directly on the fuel rails. These two holes will be fitted with a special
washer head bolt and flat washer provided in your kit, your kit will have four 1/4 20 clip nuts. Place these clip
nuts over the exposed holes in the fuel rails with the nut part facing in towards the plenum. Place the new
plenum cover over the two fuel rails and line up the holes. Peel the protective liner away from the holes and
the entire length of the side. Place the small stainless flat washer over the nut hole and install the special bolt
and snug down. It will not be necessary to make these bolts very tight just snug will work fine. You have now
created an attachment anchor for your new fuel rail covers. The flat washer will provide clearance and has
been added to allow the new cover to slide over the bolt head. You have been provided with four yellow
spacers. These spacers may only be used to allow you to attach the plenum cover under any of the four holes
should they be necessary. (With the fuel rails you have been provided with a second base plate section for
each fuel rail.)
2. Unplug the spark plug wire from all four coil packs. Loosen the lower bolts of all four coil packs and then
place the spark plug wires though the holes of the base plate and reattach them to the coil packs then slide
the fuel rail base plate under the loosened bolts and then retighten. The bottom of this section will rest
directly on the lower ridge of the engine.
3. Your new fuel rail covers can now be mounted over the washer head bolts and the bottom section of the
covers will fit snug over the top of the lower section. This area will also contain a Velcro attachment strip to
keep the bottom of the fuel rails secure.
INSTALLATION INSTRUCTIONS FOR THE 2010 CHEVY CAMARO WIRE HARNESS AND LINE TUCK
This instruction is to allow you to rearrange the factory placement of wire harnesses, vacuum lines and heater
hoses to allow the installation of American Car Crafts New Camaro Engine Bay Dress up Accessories. Providing
an alternative to the factory engine shroud cover, the procedure for rearranging the factory placement of
these items are relatively simple and straight forward. Designed to clean up the look of the engine and will
allow you a more direct access to the coil packs, fuel injectors and fuel lines much in the same way you would
be able to in a Corvette.
This procedure is completely reversible and in no way will it void any warranty or permanently alter or
damage the engine and or its performance.
You will need to purchase:
3’ of 5/8 Heater Hose
3’ of 3/4 Heater Hose
8’ of 3/8 Standard Vacuum Hose
1 Vacuum Quick Connect Release Disk
1. Remove the factory engine cover and save for restoration purposes.