American Car Craft Challenger 5.7 and SRT 8 Shifter Plate Brushed Outer Plate 2008-2013 User Manual
Page 2
PLEASE NOTE:
Installation errors are NOT manufacturing defects and parts can
NOT be RETURNED due to improper installation.
1. Once your areas have been prepared use the adhesive promoter packs/tubes
(provided) to wipe the areas of your dash/door that will be covered with your
new stainless pieces. Allow a few seconds to dry. You have been provided with
attachment tape test strips. Use one of these to test the tack. If it seams to
stick well then you can proceed with your installation. If you can not get the
test tape to stick please refer back to the special preparation instruction sheet
and repeat those procedures.
2. IMPORTANT!! Before you remove the liner for permanent attachment place
each piece into position and check the fit and also get acquainted with just how
each part sets in place. It WILL be necessary to form a few of the parts by hand
to CONFORM to the shape of your dash to insure a nice perfect fit without
forcing the shape. Once you are satisfied with the shape and fit peel the red
release liner and firmly press each piece into position.
Note: Care must be taken when cleaning your trim piece. It is a good idea to lightly dust
your kit with a clean soft cloth first in order to prevent any particles from scratching
them. Then wipe (using a new clean soft cloth or bounty paper towel) with a good
quality streak free glass cleaner.
If you have any questions during installation please call American Car Craft at
727-861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520