American Car Craft Corvette Hood Vent Grilles Perforated 2006-2013 Z06+GS+ZR1 - Manual (Page 2)

with the adhesive promoter provided. Then set the new piece of tape into
position and press firmly to set.
2. Prepare the surface of the factory grille that you exposed behind the bezel
by scrubbing it first with household rubbing alcohol to remove any dirt then
swipe the area once with the adhesive promoter provided.
3. Once preparations have been properly made place your new grille into the
opening to familiarize yourself with its position. Make sure that the new
grille sits high enough so that the black factory bezel will cover around it.
Once you have a good idea of how it is placed simply peel the release
liner from the back of the stainless grille and press firmly into position.
4. With the stainless grille installed prepare the hood opening for the black
factory bezel by cleaning off any remaining old attachment tape and then
swiping it once with the adhesive promoter provided. Once this is done
remove the red release liner from your new attachment tape on your
factory bezel then snap the factory bezel back into place pressing firmly to
set the tape.
DO NOT GET WET FOR 24 HOURS!
If any questions or problems occur during installation, please contact
American Car Craft at 727-861-1500.
Thank You and Enjoy Your Purchase.
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520
www.americancarcraft.com